Volume 18, Issue 2 (June 2021)
Abstract
(12816 Views) |
Full-Text (PDF)
(5022 Downloads)
|
Graphical Abstract
|
Highlights
- The introduction of a gas via a bubble stream into a melt is a novel and safe method for the study of the early stages of surface film formation without the complicating issue of exposed melt contamination in furnaces. The technique would need some improvements to be reliable at very low oxygen partial pressures.
- Characterization of the initial surface films on molten AZ91D and AM60B alloys were investigated in non-isothermally state under reactive (dry air, SF6 and HFC-134a) and non-reactive (UPH Argon) atmospheres by SEM and EDS techniques.
- Effect of Al element as a reactive surface element on oxidation and fluoridation behavior of the molten Mg alloy was studied.
- A comparatively study has been done in this research so that a rough and folded surface film morphology in Mg-Al alloy is compared to thin and fine wrinkled oxide film under dry air in molten pure Mg alloy.
Abstract
(19198 Views) |
Full-Text (PDF)
(6146 Downloads)
|
Graphical Abstract
|
Highlights
- The type of heat treatment has a significant effect on the hot flow behavior of AA6061 and AA6063 aluminum alloys.
- The heat treatment effects on the flow behavior of AA6061 are more than AA6063 alloy.
- The heat treatment effects on the thermomechanical behavior of both alloys decrease with increasing temperature.
- The type of heat treatment has a lesser effect with increasing deformation temperature.
- The work hardening rates are higher for aged aluminum alloys compared to annealed ones.
- The volume fraction of precipitations decreases with increasing deformation temperature.
Abstract
(18648 Views) |
Full-Text (PDF)
(4874 Downloads)
Abstract
(15513 Views) |
Full-Text (PDF)
(5080 Downloads)
Abstract
(17866 Views) |
Full-Text (PDF)
(9572 Downloads)
Abstract
(16391 Views) |
Full-Text (PDF)
(4966 Downloads)
Abstract
(15758 Views) |
Full-Text (PDF)
(5910 Downloads)
Abstract
(19857 Views) |
Full-Text (PDF)
(5153 Downloads)
|
Graphical Abstract
|
Highlights
- The low velocity impact (LVI) response of pure and GFRPs containing various loading of SWCNTs was investigated using the drop-weight impact machine
- The absorbed energy of incorporated GFRP with different weight percent of SWCNT was studied.
- LS-DYNA numerical explicit finite element code was used to simulate the impact process of neat and incorporated GFRP with functionalized SWCNT.
- Experimental and numerical LVI test results were compared in the terms of maximum contact force and back-face damage area of specimens.
Abstract
(17968 Views) |
Full-Text (PDF)
(5199 Downloads)
Abstract
(12473 Views) |
Full-Text (PDF)
(10003 Downloads)
Abstract
(22043 Views) |
Full-Text (PDF)
(5211 Downloads)
Abstract
(17420 Views) |
Full-Text (PDF)
(5275 Downloads)
Export as:
HTML
|
XML
|
RSS